Los Angeles Plumbing Services
24/7 Emergency Plumber Los Angeles.

homeTag Archives

Is there a need to replace a Building Trap?

The City’s old houses are cozy or large, but they can be a nightmare for plumbers in Los Angeles. The old-fashioned fixtures and fittings are often very old and have lasted well beyond their intended life cycles.  Modern building codes require plumbers in Los Angeles to implement certain standards, and houses that still contain the original water pipes and drains cause headaches for many homeowners. Building trap replacement is one of the essential tasks for the owners of these homes, because the existence of traps is a major problem.

What is a Building Trap and  Why You Need to Remove It!

The building trap is a U-bend clay pipe that builders would install on the exterior sewer line of houses built before the use of modern plumbing fittings. The purpose of the trap was to stop odorous gases entering the home from the sewer, and it worked by “trapping” a small amount of water in the bend – just like the S-bend under your kitchen sink does. You can check whether your home has a building trap by searching in your front garden for a cast iron “cap” in the shape of a mushroom. It’s usually located on a pipe close to the surface.

Building traps cause a range of plumbing problems for Los Angeles homeowners, such as

  • Blocked drains, caused by the accumulation of waste in the bends of the trap. Because the trap essential consists of two 90-degree elbows, it’s not possible to clear it with modern plumbing equipment.
  • Sewer leaks, caused by cracks in the clay pipe that the U-bend is made from. This allows sewer water to leach out into the surrounding soil, creating a breeding ground for bacteria and odors.
  • Root infestation, which happens when tree roots detect the presence of water within the clay pipe and penetrate to access it. This causes a catchment area for loose debris, which eventually clogs the entire drain.

Modern building codes prohibit the use of building traps, which are no longer available. This means that any renovation of your Los Angeles home needs to include a building trap replacement.

Replacing the Trap

If you find your property has a building trap, check to see whether it’s inside or outside your foundations. Exterior building traps are typically removed by excavating near to the foundation, which is usually fairly simple. Interior traps, however, require lifting of the basement floor. When plumbers in Los Angeles remove building traps, they typically replace them with two-way cleanout that provides access to both directions of the drain. If necessary, they also install a backflow prevention valve to help prevent the sewer from backing up into the home.

If your home is built prior to 1970, contact your local plumber and get an assessment of whether you have a building trap that needs replacement. It costs much less to replace it before you experience problems than it will when you have extensive damages to repair and clean-up costs to add to the process.

Hiring a Plumber In Los Angeles

While Los Angelesians are busy enjoying what has so far been a mild winter, many homeowners are planning home renovations in spring. If you’re in this category, you’ll probably need to start sourcing contractors soon for the various aspects of your project, and a qualified plumber is an important one. Hiring a plumber in Los Angeles is fortunately not too difficult, as long as you follow few basic guidelines to make sure you find the right person for the job.

Find a Service Specialist

No matter how good a local Los Angeles plumber is at clearing drains, that’s not going to help you when you need someone to install new kitchen plumbing. As with any other industry, hiring a plumber in Los Angeles depends on finding a contractor with specific experience in the work you want to be done. Using a specialist might cost slightly more than simply hiring the local handyman, but chances are you’ll get a much better quality of work as well.

Where to Start

Begin by searching online for plumbers in your area of  Los Angeles. The GTA is pretty big, and many only work in certain parts of town. Search specifically for those who offer residential plumbing options such as water service installations and drain installations, because this experience is vital to ensure quality work during a renovation. Once you find a list of potential plumbers, you can call them all for quotes on the work you want done.

Check References

It’s not enough to simply go by written testimonials on a plumbing website, because these can easily be created by anyone. When hiring a plumber in Los Angeles for an important project, you need the reassurance that comes with knowing you’ve done your homework before making a selection. It’s essential to verify that the plumber you choose has the skills and experience you need, as well as to find out whether the company is reliable and trustworthy in terms of getting the job done.

Comparing Prices

Plumbers come in all shapes and sizes and so do their prices. It isn’t always easy to compare the prices offered by one contractor with another, because they could use different methods to estimate. When you’re hiring a plumber in Los Angeles, you might find one company quotes separately for labor and parts while another provides an all-inclusive proposal. Some plumbers may prefer you to purchase your choice of fittings, but others believe this part of the job should be left to professionals. Go through every quotation you receive carefully and make sure you understand exactly what is included in each. And remember, cheap isn’t always the best choice!

Avoid DIY Plumbing

Unless you really know what you’re doing, avoid choosing DIY plumbing projects over professional renovations. This is particularly relevant when it comes to skilled trades such as plumbing and electrical, which can have serious repercussions if they are not done correctly. Not only can you end up with a half-finished project because you got too busy halfway, but you could incur huge repair costs that aren’t covered by your insurance. This usually applies to repairs to water damage, particularly if the job was not done by a qualified professional.

There really aren’t any “short cuts” to having your plumbing projects well executed. Hiring a plumber in Los Angeles remains the best and fastest way to get quality work done, and provided you do due diligence it’s also the most cost-effective way. Contact your local plumber 911 Plumbing Services for an estimate on your spring Los Angeles project now – before the season takes off and everyone is busy.

Issues To Look Into

In general a Los Angeles Plumber does more than just repair pipes and unclog drains and plumbers have to take years of training in a work to take care of the more challenging aspects of this industry. Even though it’s usually welcome to save a few dollars here and there while you are taking chances with your family security, it is well worth spending the cash to make certain that your house is secure.

Just to give you an example is the fact that, on one hand, a professional Los Angeles Plumber in this trade is well trained in setting up a hot water heater in the house,. On the other, If you as an inexperienced, in doing this type of job, and tried to do this yourself its highly possible you could be setting yourself up for disaster that could trigger serious consequences to the safety of you and your love ones. A major concern with this type of job is the fact that several times you are unable to find out whether you did it properly until it is too late. Having an expert care for this one specific area is important to keeping your house a healthy environment.

Dealing with various drainage issues is something there are very much connected with the plumbing trade. Another job is putting in what’s known as an ejector pump and it’s something that an expert must only deal with because if it’s done incorrectly and it has a poorly placed seal you’ll be able to have sewage flooding into your basement which will release strong foul odors into the air causing great difficulties for the entire household.

Speaking about drainage concerns, if you find you have a plugged drain, frequently many individuals will go to their local hardware store and buy what is known as a snake to try and save themselves a few dollars. If the issue is not all that bad you might not need a plumber for this but often what takes place is that based on the severity of your problem, if not taking care of and cleaned correctly it may result in further issues down the road. Problems such as a burst pipe or perhaps a huge leak for example that be very pricey and somewhat dangerous can take place. These are just a few examples where an expert in this trade can cut down on the health dangers within your home. 911 Plumbing Services, Inc. Los Angeles Plumber will be happy to assist you.

Pipe Location

The pipe location in your home is important for proper maintenance and water flow.

Many pipes are located in walls, floors and ceilings and are hard to locate.

If you have no idea where a leak is coming from, you’ll want to call a professional Los Angeles plumber who will have the equipment to locate the pipes in your walls, floors and ceilings.

Without having the proper tools, it can be very difficult to determine where pipes are actually located in your home.

Some older homes may have been built without the use of building codes, and if codes were followed, it’s possible that they were very lax. Today’s homes utilize stricter methods and require an adherence to building codes and statutes.

Our team of Los Angeles Plumbers have tools that will help them locate the pipes in your home. If a pipe has burst, you may waste precious time trying to find the pipe’s location when a professional Los Angeles plumber could find it very quickly.

Once the pipe location has been determined by the Los Angeles plumber, they can discuss the next course of action with you and whether it needs to be fixed in order to avoid future problems.

Rusty Hot Water

It’s alarming to see rusty water coming out of a home faucet.

However, rust in water is a very common problem.There are few places where rusty water could be coming from a one is a pipe itself or from the water heater.

It’s very crucial to determine the exact source of the rust whether its the pipe or water heater, so the situation can be corrected accordingly.

First course of action would be to clean out the water heater to remove any buildup of sediment at the bottom of the heater. This depends on the type of water heater that you have. Second, If the rusty water is coming from the pipes the only way to address the issue would be to do install new pipes.

If you are concerned about the safety of your water due to the amount of rust, it is best to have your water tested.

A professional Los Angeles plumber will be your best guide in addressing and solving this problem.

Why Tankless Water Heaters Are More Energy Efficient


 

Have you ever opened you electric bill and thought that you were paying way too much? I would bet the answer to that question is a resounding “yes!” Did you know that a significant portion of your monthly utility bill is directly attributable to your water heater? If you are one of the millions of people that are still using tank design water heaters, you are wasting money every month. But this doesn’t have to be the case. There are better alternatives on the market and, in this case, the better option is a tankless water heating system.

Now before we look at why tankless water heaters are more efficient, you have to realize that tank water heaters are actually very good at providing the hot water that is needed in most homes. They are also very reliable with a life span of 10 years or more. But they were originally designed almost 100 years ago. Much progress has been made to improve the efficiency of the design but the design is fundamentally flawed.

The flaw in the design relates to how the water that enters the tank is processed and heated prior to use in your home. The water supply will fill the tank and then the heating takes place. But if the water is not used quickly enough, then it will slowly begin to cool and require reheating prior to being used. This heating and reheating cycle is repeated again and again and again until the contents of the tank are used and then it starts all over with the new contents of the tank that replaces the water that was just used.

The answer to this flaw is a design that can heat the water on demand and only heat the water that is being used. That is the design of tankless water heating systems. It has been estimated that a tankless water heating system will lower the water heating portion of your utility bill by half. That is some significant savings!

As an added bonus, tankless systems are very small compared to tank units. You will save a lot of space by replacing a tank based water heater with a tankless model. These ultra compact units are usually mounted on a wall and are about the size of a medicine cabinet.

That having been said, we live in a world where energy efficiency is a necessity and you have to be very careful about how much energy you are using and wasting. So, while not for everyone given the cost constraints, buying water heaters that will save energy will not only help you lower your expenses every month but also the environment at the same time. If you have any questions about tankless water heaters, give 911 Plumbing Services, Inc. a call: 888-959-1911.

Water Pressure | Water Pressure Tank

Problems with water pressure are one of the more annoying and undesired things that can go wrong in your house or apartment unit. Showers become running slow and less satisfying, dishes are even more of a chore than usual. These days many people live with these and many other water problems, simply because they aren’t aware of how to fix them (or prevent them in the first place). There are, however, many options available to change your water pressure from bad to normal.

Urban Water Pressure

Most people get their water from a municipal water company. In the main lines underground, the water pressure is very high. Due to friction, this water loses its pressure between the main line and your home. It loses still more pressure between where it enters the home and the faucet it comes out of. The smaller the space is for the water to move through, the more friction there will be. If water has low pressure when it comes out of a faucet, it means that somewhere between the main line and your sink, the water is experiencing too much friction.

Sometimes, the excess friction is caused by pipes being too small in the first place. A pipe that is 1/2 inch in diameter causes significantly more friction than one that has a 3/4-inch or a full inch diameter. If your home is full of 1/2-inch pipes, replacing the ones that are easily accessible with 3/4-inch pipe will make a noticeable difference. Paying a professional to come in and replace all the plumbing with 3/4-inch pipe will make an enormous difference. People building a new home can upgrade from 1/2-inch pipe to 3/4-inch pipe for a relatively low price and save a lot of hassle in the long run.