How to Save Energy in Winter Time

The following information is mostly addressed to the people that reside in areas that temperature goes below normal level. In areas that people experience low temperature it is very important to consider the fact that it requires more energy in order to keep the hot water flowing through the pipes. There are few useful tips that can help you to keep your energy cost level low.

 

Using Insulating Blanket

First, we will start  from the water heater.  Older hot water tanks have less efficient insulation of their own. In order to test whether your water heater is loosing heat or not, put your hand against the outside of the thank, if it feels warm to your touch, then it means its own insulation is inadequate and the heat is transferring through the tank’s outer layer. Insulating blankets can be used in order to keep the water getting cold due to the outside temperature.

Wrap your electric tank in a hot water cylinder jacket available from Home Depot or Lowe’s. The jackets are made from sheet-plastic-covered insulation foam and come with an R-rating. Los Angeles Plumbers recommend using a jacket with an R-11 rating, which range in price from $25 to $60 depending on the size you need.

For gas-fired hot water heaters, you need to make sure the areas around the pilot flame remains clear of the insulating blanket, or this could catch fire. It’s best to get your local Los Angeles Plumber to install the blanket on a gas heater, unless you really know what you are doing.

Cover the External Pipes

It’s not just the hot water heater itself that benefits from insulation, but the pipes as well. Plumbers In Los Angeles recommends, that you insulate at least the first three feet of pipes leading to and from the tank, as well as any pipes that run through parts of your home that are unheated (such as an unfinished basement). Using insulate tape wrap, or snap on tubular foam insulation that fits around the pipes. The tubing is available from your home hardware store for around $10 per 5 inches of foam.

Reduce the Temperature of Your Tank Water Heater

Ok, so you like it hot. We get it, we really do. But it’s unnecessary to set the thermostat on your hot tank water heater so high that it’s boiling. Keeping the temperature between 55 C and 60 C will give you a warm enough bath or shower and make it necessary to add less in the way of cold water to get it right. It also helps to keep mineral buildup and pipe corrosion to a minimum, meaning both the heater and the pipes will last longer. Don’t forget to turn the hot water heater off or down to a very low temperature if you’re away for a few days – there’s no point in spending money to keep water hot if nobody is home!

Benefits You Can Gain

All these steps lead to a surprising number of benefits. You can realize cost savings in the short term by using less energy, and in the long term by protecting your hot water heater and pipes better and reducing the need to spend money on maintenance and repairs. Any form of saving on energy usage minimizes your impact on the environment, and we all know that Americans are fully supportive of Eco-friendly solutions. If you’re serious about protecting the planet, consider installing a solar or tank-less water heater when spring comes around. Contact 911 Plumbing Services, Los Angeles Plumbers, to discuss the feasibility of this in your situation, and the potential cost savings this could bring you.

One thought on “How to Save Energy in Winter Time

  • November 13, 2013 at 12:31 pm
    Permalink

    We’re a bunch of volunteers and opening a brand new scheme in our community. Your website provided us with valuable information to paintings on. You have done a formidable process and our whole neighborhood will likely be grateful to you.
    🙂 #$# 🙁

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *